Shop By Category

Desc
per page

6 Items

View as List Grid
  1. 1960-62 Rear Frame Crossmember, Tubular
    $99.00

    Tubular rear frame crossmember built using thick-wall 1.5" tubing & 3/16" steel.

    Fits: 1960-62 Chevy Trucks
  2. 1960-62 Chevy Transmission Crossmember
    $99.00

    Tubular transmission crossmember built using thick-wall 1.5" tubing & 3/16" steel.

    Note: The tabs are loose and "unwelded".

    Fits: 1960-62 Chevy Trucks
  3. 1960-62 Chevy Pickup Rear Dropmember, Coilovers
    $2,299.00

    The Porterbuilt 1960-62 Rear coilover suspension system is a modular suspension system designed to replace the factory components and improve ride quality, performance, aesthetics, and strength.

    Ride height measures approx. 6” when running a 30” tall tire (measurements are taken from bottom of the cab to the ground).
    DOES require modification of the stock bed floor.
    All rear kits are compatible with both long and short bed trucks.
    Designed with outboard coilovers that can accommodate up to 12" Wide Wheels
  4. 1960-62 Chevy Pickup Rear Dropmember, Airbag
    $2,299.00

    The 1960-62 Chevy Pickup Rear Dropmember suspension system is engineered to lay body with large diameter wheel/tire combinations. (Recommended to run no wider than a 10” wheel)

    Ride Height - 4"
    Deflated Height - Lay Body"

  5. 1960-62 Chevy Pickup Front Dropmember, Airbag
    $1,299.00

    The 1960-62 Chevy Pickup Front Dropmember suspension system is designed to replace the factory cross-member and steering system. It is engineered as a modular bolt-in unit that requires no welding.
    When combined with a 2.5” drop spindle, 29” tall tire, and Porterbuilt Tubular Control Arms, the Level 3 Front will set the lowest point of the factory frame rails on the ground when fully deflated.

    Ride Height - 4"
    Deflated Height - Lay Frame

  6. 1960-62 Chevy Pickup Front Dropmember, Coilovers
    $1,299.00

    The 1960-62 Chevy Pickup Front Dropmember Coilover suspension system is designed to replace the factory cross-member and steering system. It is engineered as a modular bolt-in unit that requires no welding.
    When combined with a 2.5” drop spindle, 29” tall tire, and Porterbuilt Tubular Control Arms, the Level 2 Front Coilover system will set the lowest point of the factory frame rails approx. 5-6" inches off the ground at ride height.

    Ride Height - 5-6"

Desc
per page

6 Items

View as List Grid
To Top